added ruff test

apps/autocal/config/locales/zh_CN.json

@@ -34,9 +34,39 @@
     "hint": "连接与总线初始化每次开机只需确认一次，因此收进这里；顶栏状态条持续显示结果，设置窗口可以一直开着。",
     "tab_connection": "连接",
     "tab_bus": "总线初始化",
+    "tab_axes": "轴映射",
+    "axes_hint": "总线只报告轴号，不报告它推的是哪个方向。这里的对应关系来自实际接线，运动前必须完整且不重复。",
+    "role_x": "X（工作台）",
+    "role_y": "Y（工作台）",
+    "role_z": "Z（压轴）",
+    "role_yaw": "yaw（回转）",
+    "role_pitch": "pitch（俯仰）",
+    "role_axis": "驱动器",
+    "axes_duplicate": "同一驱动器被分配给多个方向：{detail}",
     "close": "关闭",
     "chip_hint": "点击打开设备设置 — {name}"
   },
+  "move": {
+    "execute": "执行动作",
+    "execute_hint": "把选中点解算出的位姿送到平台：先回转、再俯仰，最后工作台 X/Y。压轴 Z 不动作。",
+    "stop": "停止",
+    "stop_hint": "立即停止所有轴（与顶栏「全部停止」相同）。",
+    "return_initial": "回初始位",
+    "return_hint": "五个轴全部回到零点，先退压轴 Z。",
+    "confirm_title": "确认运动",
+    "confirm_execute": "将按以下顺序移动：\n\n{steps}\n\n请确认仿真与机床一致。",
+    "confirm_return": "将把五个轴全部移回零点（先退压轴 Z）：\n\n{steps}",
+    "hold_note": "不动作：{roles}（压轴由 P7 的接触检测与压深另外管）",
+    "cancelled": "已取消，未发出任何运动",
+    "confirm_check": "移动前确认",
+    "confirm_hint": "取消勾选后，执行动作与回初始位将直接发出（停止不受影响）。",
+    "no_point": "未选中标定点，无法执行",
+    "busy": "已有运动在执行",
+    "refused": "运动被拒绝",
+    "done": "运动完成",
+    "failed": "运动失败",
+    "stopped": "已停止，后续动作已取消"
+  },
   "connection": {
     "title": "连接控制器",
     "mode": "连接方式",